Medium and Low Range Visual Systems
Self-Filling Amoules for Colorimetric Analysis
(read below for Ultra Low Range)

CHEMets® ampoules are designed for maximum simplicity and accuracy. Use them for low- to medium-range colorimetric analysis. Each ampoule is 7 mm in diameter with a tapered, prescored tip.  Reagents are vacuum sealed inside.

The CHEMets® Method: The analyst immerses the CHEMet ampoule in the sample and snaps the tip. The correct volume of sample is drawn in by vacuum, and a small inert gas bubble remains. Sample and reagent are mixed by tilting the ampoule so the bubble travels from end to end. In 2 minutes or less, the resulting color is compared to the appropriate color standards to quantify the result.

 
Low Concentrations (Less than 1 ppm.)  In most cases the cylindrical comparator is used to quantify low concentrations. The filled test ampoule is placed in the center and compared with the eight color standards surrounding it.

Medium Concentrations (Above 1 ppm.)  The flat comparator is usually used for concentrations higher than 1 ppm. The analyst places the filled ampoule next to individual standards until a color match is found.

Ultra Low Range Self-Filling Ampoules for Colorimetric Analysis

ULR (ultra low range) CHEMets ampoules are designed for maximum simplicity and accuracy in testing low concentrations. Each ampoule is 8 mm in diameter and 250 mm in length with a tapered, prescored tip, and reagents are vacuum sealed inside.

The ULR CHEMets Method
The ULR CHEMet™ ampoule is immersed in the sample and the tip is snapped off. The correct volume of sample is drawn in, and a small inert gas bubble forms. Sample and reagent are mixed by tilting the ampoule so the bubble travels from end to end. In 2 minutes or less, the resulting color is compared to the appropriate color standards to quantify the result.
ULR CHEMets enable the user to mearsure concentrations at very low levels. A cylindrical comparator is used to read the test results. The filled test ampoule is placed in the center and compared with eight color standards around it.

Visual Colorimetric Analysis - Chemets Method

Contents for Medium, Low Range and Ultra Low Range.
Test kits contain 30 ampoules, comparator(s), accessory solutions (when necessary), snap cup, and instructions. Refill packs of 30 ampoules, and accessory solutions, are available.

 

Step 1. SNAP.  Fill the snap cup with your water sample, then snap the tip of a CHEMet ampoule as shown in the diagram above.  Vacuum inside the tube will cause it to fill instantly with sample fluid and mix with the pre-measured reagent inside. Step 2.  MIX.  Mix the contents of the filled ampoule by tilting it up and down several times, each time allowing the small bubble inside to travel from end to end. Step 3.  READ.  Use one of the convenient comparators to quantify your test result.  For low range testing, view the ampoule lengthwise; use the flat comparator for medium range samples.

Chemetrics Products:

Visual Colorimetric Analysis:

-CHEMets® Method

Instrumental Colorimetric Analysis:

-VacuVials® Method

High Range Visual Colorimetric Analysis:

-VACUettes® Auto Dilution Method

Titrimetric Analysis:

-Titrets® Method

________________________________________

V-2000 Multi-Analyte Photometer for Water Quality Analysis

SAM Single-Analyte Meters

Dedicated Instruments

Useful Information on Chemetrics Products:

Chemetrics Product Brochure (.PDF)

Chemetrics- Simplicity of Water Analysis Presentation (.PPT)